TAG:
|
This document describes the firmware version, supported HTTP API version, the Linux kernel and the shell script interpreter that applies for each product. IMPORTANT NOTICES! Axis Communications AB cannot and will not be held liable for any damage inflicted to any device as a result of the information or instructions mentioned in this document. Axis Communications AB reserves the right to make changes to this document without prior notice. Axis Communications AB provides NO support for application development of any kind. Please bear in mind that the flash chip manufacturer estimates the number of writes to the flash chips to about 100,000. Writing a lot of temporary files to the flash memory should thus be avoided. Use the ram disk mounted on /tmp instead. Products with firmware version 2.xx Products with firmware version 2.xx support the HTTP API version 1.xx http://www.axis.com/techsup/cam_servers/dev/cam_http_api.htm The operating system for the following products is Linux 2.0 (elinux) and the shell script interpreter is mish. AXIS 2100 AXIS 2110 AXIS 2120 AXIS 2130 AXIS 2420 AXIS 2400 AXIS 2401 Products with firmware version 3.xx Products with firmware version 3.xx support the HTTP API version 1.xx http://www.axis.com/techsup/cam_servers/dev/cam_http_api.htm The operating system for the following products is Linux 2.4 and the shell script interpreter is ash. AXIS 250S* AXIS 2400+ AXIS 2401+ AXIS 2411 AXIS 2460 * AXIS 250S supports param.cgi in the HTTP API version 2.xx for dynamic parameter handling. http://www.axis.com/techsup/cam_servers/dev/cam_http_api_2_00.htm Products with firmware version 4.xx Products with firmware version 4.xx support the HTTP API version 2.xx (  http://www.axis.com/techsup/cam_servers/dev/cam_http_api_2_00.htm)The operating system for this product is Linux 2.4 and the shell script interpreter is ash. AXIS 205 (Axis) |